pcb-rnd - the [cycdrag] patches, negative box select
-
-When a selection is made using drag&drop (box selection), depending
-on the direction the rule for object selection differ:
-
-
drag from top-left towards bottom-right (positive sized box):
- select objects that are fully contained in the box (original behaviour)
-
drag in any other direction (e.g. bottom-left to top-right, or
- bottom-right to top-left; negative sized box):
- select objects that are even partially within the box or merely touch
- the edge of the box
-
-
-The feature can be disabled using the editor/selection/disable_negative conf
-setting.
-
-It's possible to limit the feature so that only horizontal-negative is
-considered negative size (i.e. only right-to-left dragging), using the
-editor/selection/symmetric_negative conf setting.
-
-
save/load and compatibility
-Not affected.
-
-
plans
-Work more on some rough corners of the negative direction: e.g. pads are
-handled as 0 width lines so the selection has to hit the center.
-
-
-
Index: trunk/doc/features/index.html
===================================================================
--- trunk/doc/features/index.html (revision 13635)
+++ trunk/doc/features/index.html (revision 13636)
@@ -42,7 +42,6 @@