Index: drc_query_tdx.html =================================================================== --- drc_query_tdx.html (revision 31299) +++ drc_query_tdx.html (revision 31300) @@ -16,9 +16,9 @@ translate design/layout requirements extracted from the schematics into a rule set that then can be checked by pcb-rnd. -
-Block type is "drc_query_rule" and "drc_query_const", version is "v1". +Block type is "drc_query_rule" and "drc_query_def", version is "v1". The unique identifier should be single word rule name or constant name.
Commands for drc_query_rule are: @@ -41,7 +41,7 @@
-Commands for drc_query_const are: +Commands for drc_query_def are:
command | parameter names | explanation
@@ -61,11 +61,11 @@
config) translated into tEDAx drc_query_* blocks:
tEDAx v1 -begin drc_query_const v1 hole_overlap_factor +begin drc_query_def v1 hole_overlap_factor type real default 0.0 desc How much drilled holes may overlap [-1..+1]; 0 means touching holes are reported; positive numbers allow more overlap, negative numbers report non-overlapping but close holes -end drc_query_const +end drc_query_def begin drc_query_rule v1 hole_overlap type pair hole |
---|