+
+ include your scconfig/config.log
+
+ |
+ 2. Build problems:
+ make fails
+ |
+
+ - include your scconfig/config.log
+
- run make clean; make >make.log 2>&1 ; send the resulting make.log
+
+
+ |
+ 3. Installation problems:
+ make install fails
+ |
+
+ - include your scconfig/config.log
+
- run make install >makei.log 2>&1 ; send the resulting makei.log
+
- if the error is not an obvious failure of an operation with a clear error
+ message, please explain, in details, what you expected to happen
+ (what files should have copied/linked where) and what happened instead.
+
+
+ |
+ 4. pcb-rnd doesn't find a file
+ |
+ Please make sure you have installed pcb-rnd before running it, or if
+ you are running it from source, make sure to cd to trunk/src and
+ running it as ./pcb-rnd. Only these two ways are supported. If it still
+ fails running by one of those two, please jump to point 5.
+
+ |
+ 5. pcb-rnd run time error, non-gui-related
+ |
+
+ - run pcb-rnd from the command line; append >run.log 2>&1 to the command line, reproduce the error and include run.log
+
- if the error is not an obvious failure of an operation with a clear error
+ message, please explain, in details, what you expected to happen
+ and what happened instead.
+
+
+ |
+ 6. pcb-rnd run time error, gui-related
+ |
+
+ - if you are using the gtk-gl hid, please also try the gdk hid with
+ the command line argument --gui gtk2_gdk . Please include
+ a sentence about whether the bug affects both HIDs or is gl-only.
+
- even for the most obvious-looking problem, please explain, in
+ details, what you expected to happen and what happened instead.
+
+
+ |
+ 7. pcb-rnd crashes (segfault, assertion, abortion)
+ |
+
+ - Re-run ./configure with --debug and recompile (and reinstall).
+
- Run pcb-rnd from gdb:
+
-
+ - if you are running the installed version: gdb pcb-rnd
+
- if you are running from source: cd trunk/src; gdb ./pcb-rnd
+
+ - Type this in the gdb prompt: run (optionally append a space
+ and the command line arguments you would have used for starting pcb-rnd)
+
- reproduce the problem
+
- type bt, copy&paste the result and include it in the bugreport
+
- if the problem is reproducible, please include a description how to
+ trigger it, preferrably on an empty board on a fresh start, alternatively
+ with an example file included
+
+
+ 8. pcb-rnd can't load my file
+ |
+ Please include the file in your bugreport
+
+ |
+ 9. pcb-rnd loads my file but it doesn't look good
+ |
+ Please include the file in your bugreport; please include a screenshot
+ of the file (even open in another software) to demonstrate how it
+ should look and a screenshot how it looked in pcb-rnd; please mark
+ the difference visually.
+ | |